- Back door lock
- Harness or connector
- Power back door ECU
| Last Modified: 11-29-2007 | 1.6 C | |
| Service Category: Vehicle Exterior | Section: Door/Hatch | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM000002ADP006X |
| Title: DOOR / HATCH: BACK DOOR CLOSER SYSTEM: DESCRIPTION (2008 Sequoia) | ||
|
DTC |
B2250 |
Back Door Closer Operation Malfunction |
DESCRIPTION
The power back door ECU inputs signals from the full-latch switch, sector switch and back door courtesy light switch, which are built into the back door lock. Based on these switch signals, the latch position of the back door lock is determined.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B2250 |
While back door closer is operating, malfunction is detected in position information from sector switch within specified amount of time |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
|
1. |
INSPECT BACK DOOR LOCK (SECTOR SWITCH) |
(a) Remove the back door lock
.
(b) Measure the resistance of the switch.
Standard Resistance:
|
Tester Connection |
Door Lock Latch Position |
Specified Condition |
|---|---|---|
|
3 (FSW) - 4 (E) |
Open-latch |
Below 1 Ω |
|
3 (FSW) - 4 (E) |
Over-latch |
10 kΩ or higher |
|
3 (FSW) - 4 (E) |
Full-latch |
10 kΩ or higher |
|
3 (FSW) - 4 (E) |
Half-latch |
10 kΩ or higher |
(c) Reinstall the back door lock.
|
|
2. |
CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - POWER BACK DOOR ECU AND BODY GROUND) |
|
(a) Disconnect the V5 door lock connector. |
(b) Disconnect the O30 ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
V5-4 (FSW) - O30-24 (POS) |
Always |
Below 1 Ω |
|
V5-3 (E) - Body ground |
Always |
Below 1 Ω |
|
V5-4 (FSW) - Body ground |
Always |
10 kΩ or higher |
(d) Reconnect the door lock and ECU connector.
|
|
|